Click here for a printer-friendly version (pdf)
The overall sequence involves (a) Select a channel. (b) Tune the antenna. (c) Listen for clear channel. (d) Enter chosen base ID. (e) Test the channel/base with a beacon call. (D If channel/base suitable then place call. (g) If not change channel and repeat ............... (h) Ending call.
See chart below for channel / base ID's.
Press "Tune" to tune the antenna:
Select voice mute off and set volume. Listen to determine channel is free, if not choose another or wait:
Press "B'con" and key in the required BASE ID (if different to ID displayed), (e.g. 0801 for Alice Springs.):
Press "Call" to send a beacon call and listen for the response (revertive tones). If no response within 6 seconds send beacon again. ( Press "B'call" then "Call" it is not necessary to re-enter the code) If revertive is satisfactory (strong clear tones) then go to next step, if not then return to start using another channel/base:
Press "Call" then "Enter" and key in the required telephone number. (Always include area code)
Press "Call" to start the call. If no response within 5 seconds send the call again. (Press "Call" then "Enter" then "Call", it is not necessary to re-enter the code or telephone number)
Following the "musical" revertive indicating a successful call there will be a delay of approximately 20 seconds then a recorded announcement followed by a long tone. After the tone proceed with your call.
At the end of your call a disconnect is necessary, there are two methods. The telephone party dials 99 or from the radio Press "Call" and "Enter" and "F2"(endcall) three tones indicate a successful disconnection. If no tones are heard repeat the disconnect sequence.
Return your radio to SCAN: If you are not scanning you can miss incoming calls
Assistance or Service difficulties and Faults Ph. (02)63411544
|REIDS RADIODATA HF RADIO PHONE FREQUENCIES|
* Calling Channels (PSTN to mobile) 051, 052, 081, 092, 121 and 151. Scan only these channels for incoming calls.
Selective beacon facility is available at all bases.
Choosing a base and channel : The choice of a suitable channel is determined by distance and the time of day. Higher frequencies are required in the middle of the day and for longer distances, lower frequencies at night and for shorter distances.
The closest base may not provide the best communications.
Use the beacon call facility to test a channel before making a call and remember that, if your first choice is unsuitable, there are multiple bases. As each base is only capable of handling one call at a time, it is possible that a base is busy on a channel that you cannot hear. Under these conditions the base will not respond to a beacon call until the telephone call is finished. (Wait a few minutes and try again).
If a channel is in use, please wait until it is free or choose another channel.